Welcome! Log In Create A New Profile

Could we use this code to improve our firmware?

Posted by jzatopa

jzatopa

Could we use this code to improve our firmware?
April 29, 2014 01:04PM

Registered: 11 years ago
Posts: 334

I just read this article here. I am not a programmer but it seems to me like this could be used to improve the speed of the firmwares we currently use on our printers. Is anyone able to implement this and tell us where our firmwares are spending the most cpu cycles?

WWW.ZATOPA.COM - Your Place for high quality 3D Printing Filament and accessories

Reply Quote

Traumflug

Re: Could we use this code to improve our firmware?
April 30, 2014 11:03AM

Registered: 13 years ago
Posts: 7,616

Actually, Teacup firmware was run in a cycle-accurate simulator, you can measure timings and code execution speeds accurate to the single CPU clock: [reprap.org]

Generation 7 Electronics	Teacup Firmware	RepRap DIY