Hey all,
When I set:
#define HAVE_HEATED_BED 1
the firmware will get stuck on upload to my arduino mega 2560,
when its,
#define HAVE_HEATED_BED 0
it uploads fine and i can print (without the headbed)
Im running on windows 7 Pro 64 bit
I've tried both arduino-1.0.5-r2, and arduino-1.5.6-r2-windows
Ive updated the winAVR to the latest one (as suggested on the Repetier site)
I dont have another 2560 board to test it on,
Any suggestions?
(Sorry if this has been covered somewhere already, I did search around and couldnt find anything)
