Hi, Ive been working on this for a few days now and learning what I can on how to hook up the lcd screen through spi interface to my gen7 board. I have an SD card also hooked up, but it shouldnt be hard at all to just have it set up with same spi pins, but different chip select pin to the 74hc595. Im using the modified lcdcrystal library from here:
[
playground.arduino.cc]
I have it working fine on a normal arduino uno, but the issue is that Im not 100% sure on where to add the stuff in to the marlin firmware files to get it to compile and run.
Has anyone else tried this before, and if so, have you had any luck with this?
Edited 1 time(s). Last edit at 03/16/2014 05:25PM by cae2100.
