Hey guys,
Newbie here building his first 3D printer and I've run into a problem that I can't figure out. I had compiled Marlin F/W, uploaded it to my Azteeg X3 and was able to jog axes with Repetier. I then made a settings change for steps/mm, speed etc... When I compiled and uploaded this time, Repetier did not detect the firmware and after several retries the problem persists. I then uploaded Repetier F/W and it gets detected in Repetier Host. Further attempts with compiling and uploading Marlin have produced the same result, no detection of f/w or ability to job axes. Any ideas?
Setup:
- Azteeg X3
- Repetier Host (latest)
- Marlin F/W (latest)
- Repetier F/W (latest)
Thanks
Sebastian