MENDELMAX-MARLIN-MEGATRONICS V2-OPTOENDSTOP(AXES FAULT)
Posted by Levent
|
MENDELMAX-MARLIN-MEGATRONICS V2-OPTOENDSTOP(AXES FAULT) December 20, 2013 12:42PM |
Hi everyone I have mendelmax 1.5 with megatronics with Marlin firmware and with opto endstops.
I have complete the assembly. I have checked all the cables again and again.
The position of endstops are;
y: in front of the printer
x: right of the printer mounted on x axes plastics
z:left of the printer at the bottom.
When I test with marlin test file it is Ok
I'm using printrun and slicer.
Q1) Where is x min-max, y min-max, z min-max for all printers or mendelmax????
2Q) When I test the movements and end stops they arent working normally. The motors are rotating only one way. Interesting thing is motors are turn 2 way when the flag is in the endstop
I just want to complete the printrun movement control and after the months I want to print something. So please help me and get me out of here. I'm really stuck.
IF YOU NEED TO SEE SOMETHING I CAN TAKE A PICTURE OF THAT PART AND I CAN CAPTURE A VIDEO TOO
YOU CAN ALSO USE SKYPE OR SOMETHING ELSE TO HELP ME
JUST I'M REALLY BORED. I WANT IT TO WORK.
I have complete the assembly. I have checked all the cables again and again.
The position of endstops are;
y: in front of the printer
x: right of the printer mounted on x axes plastics
z:left of the printer at the bottom.
When I test with marlin test file it is Ok
I'm using printrun and slicer.
Q1) Where is x min-max, y min-max, z min-max for all printers or mendelmax????
2Q) When I test the movements and end stops they arent working normally. The motors are rotating only one way. Interesting thing is motors are turn 2 way when the flag is in the endstop
I just want to complete the printrun movement control and after the months I want to print something. So please help me and get me out of here. I'm really stuck.
IF YOU NEED TO SEE SOMETHING I CAN TAKE A PICTURE OF THAT PART AND I CAN CAPTURE A VIDEO TOO
YOU CAN ALSO USE SKYPE OR SOMETHING ELSE TO HELP ME
JUST I'M REALLY BORED. I WANT IT TO WORK.
|
Re: MENDELMAX-MARLIN-MEGATRONICS V2-OPTOENDSTOP(AXES FAULT) December 21, 2013 02:22AM |
|
Re: MENDELMAX-MARLIN-MEGATRONICS V2-OPTOENDSTOP(AXES FAULT) December 24, 2013 03:25PM |
Sorry, only registered users may post in this forum.