[Solved]Marlin Endstops + Testing issues September 09, 2012 07:54PM |
Registered: 11 years ago Posts: 42 |
Quote
// corse Endstop Settings
#define ENDSTOPPULLUPS // Comment this out (using // at the start of the line) to disable the endstop pullup resistors
#ifndef ENDSTOPPULLUPS
// fine Enstop settings: Individual Pullups. will be ignord if ENDSTOPPULLUPS is defined
#define ENDSTOPPULLUP_XMAX
#define ENDSTOPPULLUP_YMAX
#define ENDSTOPPULLUP_ZMAX
#define ENDSTOPPULLUP_XMIN
#define ENDSTOPPULLUP_YMIN
//#define ENDSTOPPULLUP_ZMIN
#endif
#ifdef ENDSTOPPULLUPS
#define ENDSTOPPULLUP_XMAX
#define ENDSTOPPULLUP_YMAX
#define ENDSTOPPULLUP_ZMAX
#define ENDSTOPPULLUP_XMIN
#define ENDSTOPPULLUP_YMIN
#define ENDSTOPPULLUP_ZMIN
#endif
Re: Marlin Endstops + Testing issues September 09, 2012 08:15PM |
Registered: 11 years ago Posts: 42 |
Re: Marlin Endstops + Testing issues September 10, 2012 08:14AM |
Re: [Solved]Marlin Endstops + Testing issues March 15, 2016 10:36PM |
Registered: 8 years ago Posts: 5 |