I'm building a new printer using the MKS Base 1.4 board from my old printer. Everything is working great now except for the second Z motor. It is connected to E1 on the board, and I have enabled #define Z_DUAL_STEPPER_DRIVERS in Configuration_adv.h.
The Z axis seems to home decently well with a little bit of extra noise (which makes me think the Z1 and Z2 motors aren't moving at the exact same rate, but maybe they weren't perfectly level to begin with), even when it has to travel 30+mm to reach the endstop. But, when I manually tell it to move in increments, Z1 will turn just fine and Z2 seems to either barely turn or not move at all. I would think that Z_DUAL_STEPPER_DRIVERS wasn't working if it weren't for the fact that Z2 does move when homing. Any suggestions?