Hi guys , so I have a couple of questions , I mounted a rechner ka0632 sensor , on my geeetech i3 pro b , fw version marlin rc7 . So I set everything to perfection , I would understand why every time the sensor misfires , in the sense that sometimes it is as if he revealed the distance imposed to block Z and consequently the extruder rests on the floor and pulls down the whole shebang , when I send him in detection 9-point does its job , but sometimes misfires , may depend on what ?
The other question is instead after detection , where they end up all the variables spacers to compensate for the movement of Z if before I do the level car and then use slicer for this object ?
Thanks for the help guys
