Fairly new to 3D printing and doing extremely well with a RepRapGuru Prusa i3 modified with an E3D hot end and upgraded x and y components to allow for bearings instead of the plastic pulleys that came with the kit.
If you are looking directly at the printer my x motor is on the right.
I am about to upgrade with lead screws and have printed out new x components however they place the motor on the left. This is no problem for me however I can't quite work it out in my mind if this will be no issue whatsoever or if I'll have to change the home position and direction of travel in the firmware (Marlin).
Any and all help or comments welcome.
John