Extruders compatibility May 03, 2016 05:02PM |
Registered: 8 years ago Posts: 4 |
Re: Extruders compatibility May 03, 2016 07:34PM |
Registered: 11 years ago Posts: 1,049 |
Re: Extruders compatibility August 21, 2016 04:24PM |
Registered: 7 years ago Posts: 2 |
Re: Extruders compatibility November 19, 2016 01:58PM |
Registered: 7 years ago Posts: 2 |
Quote
staalc
Hi, I have a creatbot dx plus and have replaced the hot ends with e3d v5s.
It works really well very reliable. Drawback is you lose a bit of print height probably 30mm.
If your interested I can give you a write up of the mods required, it's not a direct replacement but not to hard.
Use the model with the Bowden thread to screw into the creatbot adjusting screws.
Chris
Re: Extruders compatibility November 22, 2016 02:40PM |
Registered: 7 years ago Posts: 2 |
Re: Extruders compatibility November 23, 2016 02:51AM |
Registered: 7 years ago Posts: 2 |