usb cable for ramps 1.4 January 23, 2016 05:03PM |
Registered: 8 years ago Posts: 63 |
Re: usb cable for ramps 1.4 January 23, 2016 05:41PM |
Admin Registered: 16 years ago Posts: 13,874 |
Re: usb cable for ramps 1.4 January 23, 2016 11:28PM |
Registered: 8 years ago Posts: 63 |
Re: usb cable for ramps 1.4 January 24, 2016 02:04AM |
Registered: 8 years ago Posts: 1,671 |
Re: usb cable for ramps 1.4 January 24, 2016 11:20AM |
Admin Registered: 16 years ago Posts: 13,874 |
Re: usb cable for ramps 1.4 April 08, 2016 09:55AM |
Registered: 8 years ago Posts: 29 |
Anonymous User
Re: usb cable for ramps 1.4 April 08, 2016 11:53AM |
Quote
Tocsin
Also having problems with USB. Mid print everything stops with a communications error in Repetier-Host. My first thought was the cable, which I've replaced. I then thought maybe there's a problem with firmware, so I tried updating, after 5 attempts I succeeded. Back to original setup with new cable, and again it stopped mid print (only a 10 minute test print). Now I'm going to try direct from the SD card.
I really hate USB as a system, even with the best quality leads and ferrites its pretty rubbish.