Mark8 hobbled bolt on orca v4 ?

Hi all,
is there a user that owns an Orca v4 and who has replaced Camiel's hobbled shaft with the Mark8 ?

I just got my Mark8, but the diameter is so much less, that i need to redesign the extruder parts and the mounting of them.
Maybe someone has done it already ? I would like to lend some ideas :-)

Thomas

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

Hy

whats a Mark8 hobbed bolt ?

Chri

---

[chrisu02.wordpress.com] Quadmax Intel Delid Tools

Maybe he means M8 (8mm)

---

_______________________________________
Waitaki 3D Printer

No
I mean the mk8 drive gear.

It comes with 5mm bore. I got one and only than realized my old gear is m4.
So i redesigned the extruder parts and ordered m5 bearings.

I now wander what extrusion ratio increase I must recon with,
Compared to the old " Camiel" hobbed shaft.

Thomas

Edited 1 time(s). Last edit at 08/18/2014 08:52AM by Replace.

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)