Welcome! Log In Create A New Profile

useing threaded bar. software

Posted by jhdgkss

jhdgkss

useing threaded bar. software
February 24, 2010 06:58AM

Registered: 14 years ago
Posts: 8

Hithere iam building a repstrap but i am useing screw thred of the machine . is thede any repraprox. does the reprap softwre make any allowence for this type of set up i.e number od steps to distance travelled by tje cqrraige to drivethe axias sorry for the spelling i am typing on my phone

Reply Quote

rhmorrison

Re: Software for using threaded bar
February 24, 2010 07:15AM

Registered: 14 years ago
Posts: 3,742

YES, you can configure the RepRap software separately for X, Y, and Z-axis as well as for Extruder 0, 1 and 2. Each axis can specify movement in steps/mm as well as Working Size.

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse