Welcome! Log In Create A New Profile

i3 rework x-carriage for lmE8uu bearings

luismanson

i3 rework x-carriage for lmE8uu bearings
March 17, 2014 11:16AM

Registered: 10 years ago
Posts: 371

Hello, i want to print this part for my bearings, since they ar 16mm insteado of 15, prusa sources do have an option to enable 16mm bearings, however i can not find sources for the part i have, from a i3 rework or the already made stl

X-Carrage-2.jpg

Edited 1 time(s). Last edit at 03/17/2014 11:17AM by luismanson.

Reply Quote

PvtDBJackson

Re: i3 rework x-carriage for lmE8uu bearings
March 18, 2014 04:42PM

Registered: 10 years ago
Posts: 20

Let me know if this works. This should fit the larger LME8uu bearings (16mm OD x 25mm L). All other interfaces were kept the same (hole locations, rod spacing, etc).

Reply Quote

Attachments:
open | download - Prusa-i3-X-Carriage-LME8uu.STL (350.3 KB)

luismanson

Re: i3 rework x-carriage for lmE8uu bearings
March 18, 2014 07:46PM

Registered: 10 years ago
Posts: 371

thanks you very much!!
where did you find the source/scad?

Reply Quote

PvtDBJackson

Re: i3 rework x-carriage for lmE8uu bearings
March 19, 2014 09:37AM

Registered: 10 years ago
Posts: 20

I made it myself in SolidWorks.

EDIT: Also now on Thingiverse: [www.thingiverse.com]

Edited 1 time(s). Last edit at 03/19/2014 10:01AM by PvtDBJackson.

Reply Quote

luismanson

Re: i3 rework x-carriage for lmE8uu bearings
March 19, 2014 05:38PM

Registered: 10 years ago
Posts: 371

good work, thanks! grinning smiley