Welcome! Log In Create A New Profile

frame

dissidence

frame
January 09, 2010 01:57PM

Registered: 14 years ago
Posts: 800

i did find an interesting frame to build my repstrap out of, it is a chair base, not has small has i would like but i think it will work nicely.

reprap%2Bto%2Bbe%2B006.JPG

i think it should work well any how, any other people tried something like this.?

i am going to try to make it like mendle with the extruder on two axis and the bed going one one axis

sorry about the size of the pic

Reply Quote

Grogyan

Re: frame
January 09, 2010 03:44PM

Registered: 14 years ago
Posts: 458

Your worried about the size?

Lol

My RepStrap is twice as tall and just as wide as the chair.

It should do quite well as a Mendel RepStrap

Reply Quote

BodgeIt

Re: frame
January 10, 2010 07:06AM

Registered: 15 years ago
Posts: 478

Nice re-use case love this kind of re-cycling if you can design it so that you can still sit down while it prints that realy would be good.!

Edited 1 time(s). Last edit at 01/10/2010 08:11AM by BodgeIt.

Bodge It [reprap.org]
=======================================

BIQ Sanguinololu SD LCD board	BIQ Stepcon	BIQ Opto Endstop
BIQ Heater Block PCB	BIQ Extruder Peek clamp replacement	BIQ Huxley Seedling
BIQ Sanguinololu mounting	BIQ standalone Sanguinololu or Ramps mounting	Print It Stick It Cut it

My rep strap: [repstrapbertha.blogspot.com]

Buy the bits from B&Q pipestrap [diyrepstrap.blogspot.com]
How to Build a Darwin without any Rep Rap Parts [repstrapdarwin.blogspot.com]
Web Site [www.takeaway3dtech.com]

Reply Quote

rhmorrison

Re: SIZE
January 10, 2010 07:19AM

Registered: 14 years ago
Posts: 3,742

WOW - just think of the possible usable print area with that thing!
You could probably do 50 cm x 50 cm by 30 cm high!
Of course the build time would be also proportionally longer. spinning smiley sticking its tongue out

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse