Welcome! Log In Create A New Profile

Extruder Gear Pops Out - what other options are there?

bryancostanich

Extruder Gear Pops Out - what other options are there?
December 05, 2013 06:01PM

Registered: 10 years ago
Posts: 25

Hey all! i built a reprappro mono mendel, but the extruder gear keeps popping out when i'm running it. i've tried tightening the bolts to keep pressure on the filament in there too, still no good. i actually think it's kind of a crappy design.

is there a list some place of other options for the extruder feeding setup? i found lots of designs for the hot end, but not the feeder part.

thanks!

Reply Quote

swilson100

Re: Extruder Gear Pops Out - what other options are there?
December 10, 2013 03:31PM

Registered: 10 years ago
Posts: 8

If it's the type like in the link below use it to print a wade type then bin it.
[reprap.org]

Reply Quote

bryancostanich

Re: Extruder Gear Pops Out - what other options are there?
January 06, 2014 02:34PM

Registered: 10 years ago
Posts: 25

that's the one. "bin it?"

Reply Quote

jbernardis

Re: Extruder Gear Pops Out - what other options are there?
January 06, 2014 08:49PM

Registered: 11 years ago
Posts: 1,320

I think by "bin it" he means throw it in the trash. smiling smiley

Reply Quote

bryancostanich

Re: Extruder Gear Pops Out - what other options are there?
January 07, 2014 12:40PM