I am not sure if this is an electronics or mechanics question.
Is it possible to use 4 steppers for one axis (z)?
I would have to splice 2 and 2 to use with Ramps given only 2 z inputs, but would this work?
Any downsides?
My reasoning for wanting to do this is for balance rather than for torque/power.
I am finding that with a larger bed, no matter what I do I cannot seem to get it balancing properly with only one side being supported for a larger bed (400mm x 400mm) and I know I can do it with 4 motors, just not sure I can, or should.