Welcome! Log In Create A New Profile

Advanced

BQ Ciclop 3D scanner

Posted by owens 
Re: BQ Ciclop 3D scanner
February 11, 2016 08:51PM
If you are looking for scan shield but don't want to build your own (because its pretty much impossible to land a ZUM Scan Shield in the states) I will be producing a bunch. They are for my own version of the Ciclop but they have identical functionality to the ZUM scan so you can use it to build any 3D scanner you want. [www.kickstarter.com]
Re: BQ Ciclop 3D scanner
March 21, 2016 01:48AM
Hi there,

I purchased my kit from reprap.com.

I can't get my ciclop to scan. I am having trouble with the auto check and calibration.
I get these error messages. I am using horus software.

Auto check - Check Motor Direction and Pattern Position and try Again.
Calibration - Laser Calibration failed. Please try again.

I am using Ardruino Uno and Zum Scan Boards.
I will be thankful for your help.

Regards,

waqz36
Re: BQ Ciclop 3D scanner
May 06, 2016 06:43AM
Hi, I'm hoping to build the BQ Ciclop scanner and have a logitech C920 that I could use instead of the C270. I realise that the stl file holding the camera will need to be modified. But I have a few other questions;
1) Is it necessary to remove the lense cover of the camera due to its distorting effect on the laser or is that only done on the C270 so that the camera manual focus may be adjusted?
2) Is the lense center height in the plastic housing a critical dimension?

Thanks in advance.
Re: BQ Ciclop 3D scanner
July 23, 2016 05:17PM
I'm missing about 8mm off the bottom of my scans. I've tried changing the distance setting in calibration (from base to the top edge of the first square) and it doesn't change anything. Wondering what i'm doing wrong here?
Re: BQ Ciclop 3D scanner
July 24, 2016 01:43PM
Printed a full size platform, i was using a purchased acrylic one before that i drilled the holes in a little off center, and it wasn't quite as thick. Still missing the bottom few mm. after replacing the plate. Other than that the scans are great.

A guy at work told me that you can make a solution to cut down the reflectivity of objects out of 3:1 alcohol and baby powder. I'm going to try it on a nice shiny Matchbox car and see how it works.
Re: BQ Ciclop 3D scanner
August 03, 2016 04:41AM
After building Kossel 3D Printer, i am planning to build something different Perhaps 3D SCANNER will be fun to make.

Thinking which one is better to buy ?

Since this will be for the first time , budget will be limited. So thinking to start with DIY kit.

Any suggestion guys ?
Re: BQ Ciclop 3D scanner
December 17, 2016 03:03AM
I have just built a Ciclop scanner and I am now getting to grips with the calibration. It is very sensitive to the ambient light but I am now getting some pretty detailed scans even if there are holes in them.
I found some of the parts difficult to print on my reprap printer and I ended up buying a set of blow moulded parts from Hong Kong on Ebay. Cheating maybe but the end job is good.
The scanner seems ideal for copying small objects that fit a 200 x 200 print bed.
I have also built a Skanect using an xbox 360. It is for larger scans such as full body and head and shoulders scans.
Sorry, only registered users may post in this forum.

Click here to login