Welcome! Log In Create A New Profile

Advanced

Help with nano and GRBL

Posted by regpye 
Help with nano and GRBL
March 01, 2018 02:43AM
I have a EleksMakerĀ® ManaSE 2 controller board on a home built laser engraver.
The board has a Arduino nano and has been programmed with GRBL 1.1f
The board has only drivers for the motors and a laser module connection.
It is working fine, but I wanted to add a couple of extra controls for pause and resume, but the board doesn't have any connections for those.
It also doesn't have and limit switch connections which would be useful if they were there.
Can I add my own to the Arduino nano pins directly?

Edited 1 time(s). Last edit at 03/01/2018 02:44AM by regpye.

Genie MagikMaker 3D Printer - Reg's Genie Hotend - My_i3s - SmartRap 3D Printer variations
Made in South Australia
[regpye.com.au]
"Experience is the mother of all knowledge." --Leonardo da Vinci
Sorry, only registered users may post in this forum.

Click here to login