Welcome! Log In Create A New Profile

Advanced

CNC/3D printer hybrid

Posted by melvinbrucepaton 
CNC/3D printer hybrid
April 26, 2016 02:16AM
Hello All

I am building a cnc / 3d printer hybrid,

[www.instructables.com]
I have copied this one,
when i move the y axis forward through the manual controls of repetier it moves, but when i try move the y axis back, then the z axis moves?
i read some where the firmware i am using might be to old for the new board? if so where do i get the new firmware?

thank you
Melvin
Re: CNC/3D printer hybrid
April 26, 2016 10:16PM
Problem resolved, turns out i needed to add the enable wire from the ramps 1.4 to the DQ542ma"s as well as enable the the enable xyz in config h.
Sorry, only registered users may post in this forum.

Click here to login