Welcome! Log In Create A New Profile

HELP Prusa electronics

Posted by mxcobra

mxcobra

HELP Prusa electronics
August 12, 2011 06:33AM

Registered: 12 years ago
Posts: 31

Ok, I think i ordered the wrong parts... But I hope maybe someone can help me.

I order up this:
[www.techzonecom.com]

It came in, and looks like good quality stuff. but came with ZERO directions... After looking more @ the controls it looks .like it’s more for the huxley.

Has anyone else used the techzone stuff in the prusa?

Thanks
-Dave

Edited 1 time(s). Last edit at 08/12/2011 06:42AM by mxcobra.

Reply Quote

rhmorrison

Re: HELP Prusa electronics
August 12, 2011 06:42AM

Registered: 14 years ago
Posts: 3,742

See the following pages in the wiki:

Generation 3 Electronics/Tech Zone Remix

Generation 3 Electronics/Tech Zone Remix/How to

Generation 3 Electronics/Tech Zone Remix/Installation

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Reply Quote

mxcobra

Re: HELP Prusa electronics
August 12, 2011 06:47AM

Registered: 12 years ago
Posts: 31

Thanks,
Those links help thanks .... But wow, I have some work cut for making the cables & pins !!

Does anyone have photos of the Gen 3 stuff hooked up to the prusa? Just looking to get a good idea for board placement, and cables.

Reply Quote

rhmorrison

Re: HELP Prusa electronics
August 12, 2011 06:59AM

Registered: 14 years ago
Posts: 3,742

See Generation_3_Electronics/Tech_Zone_Remix/How_to#Mounting_plate/Thick_sheet.

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Reply Quote

mxcobra

Re: HELP Prusa electronics
August 24, 2011 03:41PM

Registered: 12 years ago
Posts: 31

Bob,
Thanks for the help, I'm tossing in the towel in the GEN3 stuff... I should have done more homework before I picked them up... I will be ordering up a RAMPS set soon. Much easier from what I have been reading.