Merci DeuxVis, mon anglais est beaucoup mieux que mon français, mais j'essaie!
Thanks for your suggestion -I do indeed have a multimeter and will check out the current. I think the Mendel motors are slightly larger -"NEMA 14".
For anyone else encountering a similar problem: I emailed Techzone and received the following response: "If the other axes are adjusting fine, but the X isn't then it is possible there is a cold solder joint on the trim pot. if none of the axes adjust properly then there is probably something else happening and we need to figure it out." So I might have to send it back for a replacement...
BTW - I did manage to adjust the Y axis to 45 degrees C, so it very well might be the cold solder problem :
Jacqueline
Our Mendel journey so far
Edited 1 time(s). Last edit at 07/21/2011 12:39PM by JLudlow.