hey
so im trying to upload firmware to my new gen6 electronic that i got on ebay :
[cgi.ebay.ca]
im thinking it has a bootloader on it because windows installed drivers for it,
ive downloaded and installed arduino and sanguino and ive open the fiveD firmware but it still wont upload i just keep getting this error message in arduino
Binary sketch size: 23612 bytes (of a 63488 byte maximum)
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51
ive used both arduino 022 and then 018 and still no luck,
repsnapper doesnt recognize the printer so i dont think that there is a previous firmware on it at all
any help getting this working would be great
cheers
-Olivier