Greetings!
I just purchased a new BIQU MKS-BASE V1.5 Plate Controller Board for 3D Printer Ramps 1.4 for my Folger Tech Kossel 3d printer. Looks like a cool board and I hope it performs well when I turn it on. The wiring is pretty straight forward and I feel I can connect everything except a BLTouch auto bed leveling probe.However, there is one problem I have run into so far. (
Of course, it always has to the be problem that puts your project on hold) There is NO directions on where to wire the BLTouch probe (5 wires in all) to the MKS-BASE v1.5 board. I see directions for earlier boards, but could not get the earlier board through Amazon.
Does anybody here have a MKS Base v1.5 board and successfully connected a BLTouch(or any other sensor) to this board? BTW, I am putting glass over the aluminum plate. I may manually level the bed, but would strongly prefer to do this via auto-bed leveling approach.
Thanks again.
Edited 1 time(s). Last edit at 06/27/2017 11:59AM by panadar.