I have a Z max endstop set up on my printer. The entire homing routine works fine, but when I check what the printer thinks its Z position is afterwards, it says 300mm. From what I have read, shouldn't the printer assume it is at Z_MAX_LENGTH after it hits the endstop? I have this value set to 95 - nowhere near 300.
I am using Repetier Firmware and a RADDS board.
Yeah I already have the start gcode set up. It seems like kind of a hack though and it would be nice to be able to tell the printer to go to Z=0 before or after prints.
I don't see manual_home_position_z anywhere in configuration.h for Repetier, unfortunately. I would switch to Marlin but it's not very reliable on RADDS.