Hi,
I am replacing the control board from the Ridgidbot to a Rumba.
400W 24V PSU
using stock hotbed (24v)/thermistor/hotend (24v)/motors (single extruder setup)
using 4x a4988
Marlin 1.0.2 firmware with no LCD
Motherboard is setup for Rumba (80)
I got as far as getting the X,Y,Z motors moving on the correct directions with proper endstop settings,
steps for x,y,z configured
my problem is that when using Pronterface to turn on the hotend or heatbed it will not respond or turn on so i can calibrate the E steps.
Is there anything else to configure to make the board work with a 24V heatbed and 24V hotend cartridge?
It did try the MKS V1.3 on 24V and it was running fine so i think there might be something that I am missing on the Rumba.
Cheers,
Ryan
