Welcome! Log In Create A New Profile

Duet- thanks DC42!!!

Posted by Epop

Forum List Message List New Topic

Epop

Duet- thanks DC42!!!
May 11, 2015 04:16AM

Registered: 9 years ago
Posts: 93

First solid print. smiling smiley

unchanged settings from 'Now its broken; replaced E0 motor~ didn't skip once. all sizes are within .2mm(~.01") of design

Slic3r - .3 mm layer height- est. time 3 someodd hours, actual was ~45 min... its an adapter for 3D Systems origin blocks to E3D V6 hot end.

less than 5min support removal using needle nose plyers only... and I just ripped it off (its 2am... i have work tomorrow smiling smiley

)

Reply Quote

Attachments:
open | download - ADAPTER SIDE NO SUP-WEB.gif (222.5 KB)
open | download - ADAPTER SIDE-WEB.gif (263.8 KB)
open | download - ADAPTER BOTTOM-WEB.gif (492.3 KB)

dc42

Re: Duet- thanks DC42!!!
May 11, 2015 04:29AM

Registered: 10 years ago
Posts: 14,672

Glad you got it working! The estimated end time is typically pessimistic until a few layers have been printed, because it is normal to set slic3r to print the first layer more slowly than the others, and the estimation code doesn't allow for the print speeding up after the first layer.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].