Forgive me if this has been answered in another thread which I missed.
On the page discribing the Printrboard, rev F4, elsewere on this site I find the following:
Near the top, one of the power options
Features
-- Logic & Motors supplied by ATX or laptop power supply (12 - 20V 120W minimum)
Near the bottom
Board Power
... Connect this Power Input directly to any 12VDC power supply ...
Can a 20VDC power supply be used with this board?
If so will it supply a higher voltage to the stepper motor if needed?
Thank you.
Larry
Edited 1 time(s). Last edit at 02/17/2015 09:49AM by Lab2.