Melzi - Not working X-axis
Posted by silensilen
|
Melzi - Not working X-axis January 30, 2015 06:08AM |
Registered: 9 years ago Posts: 5 |
Built from a kit of Huxley. Motherboard Melzi 1284p - prepared by the seller. Not working X-motor. Commands are sent, but the engine is idle. Motor ok - checked on the Y-connector. I believe that an integrated driver for the X-axis is faulty. No dangerous manipulation motherboard I did not. Maybe the problem is in something?
Sorry for my english
Sorry for my english
|
Re: Melzi - Not working X-axis January 31, 2015 04:34AM |
Registered: 13 years ago Posts: 7,616 |
Same as in the other thread: connect the X stepper to a working axis to find out wether it works at all. And always power down before disconnecting a stepper.
| Generation 7 Electronics | Teacup Firmware | RepRap DIY |
|
Re: Melzi - Not working X-axis January 31, 2015 05:39AM |
Registered: 9 years ago Posts: 5 |
|
Re: Melzi - Not working X-axis February 01, 2015 04:23AM |
Registered: 13 years ago Posts: 7,616 |
Then the stepper drivers are at fault. Too bad they aren't replaceable.
| Generation 7 Electronics | Teacup Firmware | RepRap DIY |
|
Re: Melzi - Not working X-axis February 01, 2015 08:56AM |
Registered: 9 years ago Posts: 5 |
Sorry, only registered users may post in this forum.