Problem with Ramps 1.4 and Arduino October 15, 2014 06:13PM |
Registered: 9 years ago Posts: 9 |
Re: Problem with Ramps 1.4 and Adruino October 15, 2014 08:53PM |
Registered: 11 years ago Posts: 1,320 |
Re: Problem with Ramps 1.4 and Adruino October 15, 2014 09:33PM |
Registered: 9 years ago Posts: 9 |
Re: Problem with Ramps 1.4 and Adruino October 16, 2014 05:30PM |
Registered: 10 years ago Posts: 581 |
Re: Problem with Ramps 1.4 and Adruino October 16, 2014 09:40PM |
Registered: 9 years ago Posts: 9 |
Quote
3dkarma
Send M119 to the printer to report end stop status. If they're all triggered the motors won't move. If they are, invert them in the firmware.
Re: Problem with Ramps 1.4 and Arduino October 17, 2014 04:03PM |
Registered: 9 years ago Posts: 9 |
Re: Problem with Ramps 1.4 and Arduino October 17, 2014 04:48PM |
Registered: 10 years ago Posts: 581 |
Re: Problem with Ramps 1.4 and Arduino October 17, 2014 05:03PM |
Registered: 9 years ago Posts: 9 |
Re: Problem with Ramps 1.4 and Arduino October 17, 2014 05:06PM |
Registered: 10 years ago Posts: 581 |
Re: Problem with Ramps 1.4 and Arduino October 17, 2014 06:12PM |
Registered: 9 years ago Posts: 9 |
Quote
3dkarma
Check your steps per mm setting? It may be off by a factor of 10. Use the reprap calculator to get the correct settings for your printer.