I've built the 1.2 MoBo (the reprap configuration here: [
reprap.org] ) and have one remaining question. The pins on the 3.3V voltage regulator appear to be clear, but the pin on the 100mF cap isn't so visible. It looks like the + leg of the cap is in the same hole as the leftmost pin of the voltage regulator (which makes sense to me as a smoothing cap) but I'm not completely sure.
Can anyone confirm that's the configuration?
Also, the parts list on the 1.2 MoBo had significant problems. The straight break-off headers weren't listed, nor was the voltage regulator or 100mF cap, and several components weren't necessary for the reprap config, so I bought them but didn't know I didn't need them until the actual build.
I've learned now that I should simulate the build for the other electronics to make sure I actually use the components, but it was an really annoying lesson to learn.
