Print bed thermistor constant 170°C reading ... worked before ;( July 21, 2014 03:16PM |
Registered: 10 years ago Posts: 77 |
Re: Print bed thermistor constant 170°C reading ... worked before ;( July 21, 2014 04:11PM |
Admin Registered: 17 years ago Posts: 7,879 |
Re: Print bed thermistor constant 170°C reading ... worked before ;( July 21, 2014 04:51PM |
Registered: 10 years ago Posts: 77 |
Re: Print bed thermistor constant 170°C reading ... worked before ;( July 21, 2014 05:16PM |
Admin Registered: 17 years ago Posts: 7,879 |
Quote
LeChuck71
uha bad news ;(
but how could I shorten the thermistor input to12V?
Quote
LeChuck71
I have a the E3D fan connected to the 12V power supply. The additional cooling fan for the PLA was added after the symptoms occured.
How can I "repair" this? Replace the arduino board or the ramps? can i replace any part on the boards?
Quote
LeChuck71
Sorry for the many questions, I just want my bed heating up again
ah and probably the most important one, how can I prevent this from happening again?
Re: Print bed thermistor constant 170°C reading ... worked before ;( July 21, 2014 05:34PM |
Registered: 10 years ago Posts: 77 |
Re: Print bed thermistor constant 170°C reading ... worked before ;( July 22, 2014 11:07AM |
Registered: 10 years ago Posts: 77 |