Hi Guys,
I'm about half way through my very first build of a Rostock Delta and everything is going great so far but I have just run into a small issue that has me confused as hell.
I purchased one of the G3D Ultra kits off ebay, see here:
G3D eBay, purely because I figured a kit like this would help me get started, seeing as I'm so new to this. It has been pretty good so far and I have just started wiring everything up, where I have ran in to my first issue, the endstops.
The endstops provided in the kit are based on the MakerBot Mechanical Endstop v1.2 which has a 4 pin connector (SIG + GND + GND + VCC), but the cables that have been provided to be used with them are 3 pin connectors which is where the confusion is.
At first thought I figured they provided me with the wrong cables but this can't be correct as they sell quite a lot of these kits (according to their feedback) and they seem to know what they're doing because they were just funded on Kickstarter for one of their own commercial builds.
Am missing something? Is there anyone here that's able to shed some light on how to wire up these endstops? I emailed them last night which I'm still waiting to hear back but figured I would ask here also to see if anyone else knows the answer and to keep it public for anyone else that may run in to the same issue.
Also something to note, there was an information page "wiki.makerbot.com/me1" but this no longer exists.
Thanks in advance guys.