Hi
I have read and just want to make sure that I am doing the correct thing to set the currect limits to the stepper drivers on my Sanguinololu board. The board was fully assembled and has the stepper drivers in. ( Power supply is 12v 29amp Screw Terminal type )
1. Do I connect all the Stepper motors ( Nema 17 2.5A (U) 1.8deg/step ) to their respective Stepper Drivers first( making sure the wires are correct ).
2. Then power the board.
3. The take my multimeter and Put the (+) test probe on this Ref and put the (-) probe to ground. Check the reading and adjust the screw on the Stepper driver. Also what should the Setting be ?
Just want to make sure this procedure is correct and that I am not going to blow the drivers or anything else.