hello, i got a prusa with a gen 7 1.4.1 board.
avalable hardware: avrdragon with avr studio 6, serial usb to ttl stick, win 7 platform.
i followed the description regarding the teacup firmware and shoot somehow the avr644 chip, not even able to erase it or read out or anything.
got a new chip and tying to program it.
copied the bootloader with avr studio, since the arduino IDE does not support the programming board.
seems to work fine
question 1:
now what i need to know is: what fuses needs to be set (with avr studio):
s8515c
WDton
Spien
eesave
bootsz
bootrst
ckopt
bodlevel
boden
sut_CKSEL
high
loW
Second question:
has anyone a configurated firmware for the gen 7 1.4.1 board with (optional) supporting sdcard and LCD?
i do understand that every board needs some finetuning for the setup regarding the setup but having a firmware that is working on another gen 7 1.4.1 would help a lot.
Background:
3 days ago i did not had any experience with programming, and now i´m trying to do it with avrstudio since that is the only way it seems to work to install the firmware. sereal connector is not working yet and not able to establixh connection by some reason. tried it with the 1.3 and 1.4 board same issue, (propably the usb to ttl converter, it runns with 3.6 volt signal on rx and tx. so should work but unable to establish connection. need to set the fuses first i suppose.
i know it seems a bit mutch to ask, but I realy have trid for 3 days to solve it on my own and now i´m desperate, i see no chance to solve it on my own.
best regards
nubi