Printrboard power supply

Hi all,

We just upgraded our Gen6 board to a printrboard so we would have heatbed controls. We have it all wired up, but can't seem to get it to power on. We've checked the wiring with our multimeter & current is running through the wires. We're using a power supply similar to this power supply. My question is do we have to use a modified ATX power supply with the printrboard? Our power supply was working just fine before we upgraded our electronics. Thanks!

Lindsay

It turns out we answered our own question. We went out & bought a cheap atx power supply. As soon as we got it plugged in the board lit up like a Christmas tree. Go figure. But at least one problem is solved.