I have a Generation 7 1.3.1 board, and i can upload the bootloader (and a firmware .hex file) using a direct parallel programmer (dapa)
i can move the steppers using pronterface.
i cant, however, load the firmware on top of the bootloader.
this would make it easier to make changes....
this is the verbose output of arduino upload; sorry for the scrolling, i thought you guru's could see something i'm missing.
sorry the file is long winded, but i dont really know what to exclude.
Attachments:
open |
download -
Arduino IDE output - Teacup
(29.5 KB)