Welcome! Log In Create A New Profile

Duet Motor loom connector????

patrickrio

Duet Motor loom connector????
November 25, 2015 10:09PM

Registered: 9 years ago
Posts: 233

I think for my mini delta printer, I want to use the single motor loom connector rather than the individual connectors on the Duet. A single motor loom will be easier to work with.

dc42, do you know of a good and cheap source for an already made connector that has decent AWG ribbon wire already attached???

Reply Quote

dc42

Re: Duet Motor loom connector????
November 26, 2015 05:21AM

Registered: 10 years ago
Posts: 14,672

I don't know of anyone else who is using the single motor loom connector. That connector was dropped on the Duet 0.8.5.

As it's a standard 2x20 pin 2.54mm pitch connector, an old cable for connecting PATA hard disk drives or CDROM drives on a PC should do. Make sure you get the 40-conductor version, not 80-conductor. Here [www.ebay.co.uk] is an example.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

patrickrio

Re: Duet Motor loom connector????
November 26, 2015 08:33AM

Registered: 9 years ago
Posts: 233

Ahhhhh.... I just cleaned out my wiring box about a month ago... and threw out about 20 of these!!!!!! darn.