Hi,
I have a fairly heavy print bed running on a belt mechanism. I would like to hook my 2 stepper motors in series for the Y Axis to work together, each controlling a different belt. (Prevent belt slipping)
My Z Axis is wired in series, and works flawlessly, my question is, will it work with the Y axis too?
I am using the new AZSMZ Mini with a 24V 20A psu.
My stepper motors have a low amperage, and power consumption:
200 steps per revolution (1.8 deg/step)
2 Phase bipolar 4 wires
Rated Voltage 2V DC
Rated Current 1.2A
Phase Resistance: 1.7 Ohm ± 10% (20º C)
Phase inductance: 4.5 mH ± 20% (1kHz 1 V rms)
Holding torque: 0.4 N.m Min.
My stepper drivers are the reliable DRV8825's handling 1.7 A per driver (As said by seller who sold me the AZSMZ)
Cons and Pros?
Thanks! Any feedback is greatly appreciated!