Changing Z-Axis position for dump point?! March 31, 2011 06:18AM |
Registered: 13 years ago Posts: 395 |
Re: Changing Z-Axis position for dump point?! March 31, 2011 06:35AM |
Registered: 14 years ago Posts: 3,742 |
Quote
Obi wan Kenobi
Luke, use the source!
Re: Changing Z-Axis position for dump point?! March 31, 2011 10:11AM |
Registered: 13 years ago Posts: 1,780 |
G1 F60.0 G1 Z30.0
G28 Z0
Re: Changing Z-Axis position for dump point?! March 31, 2011 04:47PM |
Registered: 13 years ago Posts: 395 |
; GCode generated by RepRap Java Host Software ; Created: 2011-03-31:00-34-22 ;#!RECTANGLE: M110 ; Reset the line numbers G21 ;metric is good! G90 ;absolute positioning M140 S115.0 ;set bed temperature and return T0; select new extruder M113; set extruder to use pot for PWM G92 E0 ;zero the extruded length G28 X0 ;set x 0 G28 Y0 ;set y 0 G1 F0.016; feed for start of next move G1 X3.7 F3000.0 ;horizontal move G1 X126.3 ;horizontal move G1 X130.0 F0.0 ;horizontal move G28 Z0 ;set z 0 <-- Here the Z-Axis is set to the 0 Position - can I move it there? --> Else I would insert the first mentioned code-segment here...right? M109 S225.0 ;set temperature and wait G1 F3000.0; feed for start of next move G1 E1000.0; extruder dwell <-- this is the pruge process, right? --> This is where I would insert the second code segment...? G1 F0.016; feed for start of next move G1 F18000.0; feed for start of next move G1 E960.0; extruder retraction G1 F0.016; feed for start of next move G92 E0 ;zero the extruded length
Re: Changing Z-Axis position for dump point?! March 31, 2011 04:55PM |
Registered: 14 years ago Posts: 3,742 |
Re: Changing Z-Axis position for dump point?! March 31, 2011 05:17PM |
Registered: 13 years ago Posts: 395 |
Re: Changing Z-Axis position for dump point?! March 31, 2011 11:30PM |
Registered: 13 years ago Posts: 1,780 |
Re: Changing Z-Axis position for dump point?! April 01, 2011 03:55AM |
Registered: 13 years ago Posts: 395 |