losing notification-messages from the stepmotor devices

the stepmotor-devices are not sending notifications if the motor reaches the min-sensor during a dda-operation.
e.g.
in stepper exerciser:
home for x and y
line test: to x:700, y:700 (moving ok)
line test: to x:0, y:0 (moving ok)
waiting for notification until timeouts
(then x has the value 1 and y the value 3)

i get the result with the standard firmware version 1.0 (and with my new version).

i think the problem is, that in the function forward1() the variable function is set to func_idle if the min-sensor is reached. after than, no notify is send in the timerTick() function.

Okay, good to know. Can you fix this problem?

hi kevin,

here is the fix for this problem.

best
andreas

andreas Wrote:
-------------------------------------------------------
> hi kevin,
>
> here is the fix for this problem.
>
> best
> andreas

Andreas,

I programed and ran V7 last night and it seemed that can only run my x and y axis in one direction?? It might be me also tonight I was going to try the one that is on source forge as a base line to see if that works in both directions since I just rewired my stepper motor (my X was not the one that was reversed it was my Z)

So I will let ya know.

Bruce

brucew Wrote:
-------------------------------------------------------
> andreas Wrote:
> --------------------------------------------------
> -----
> > hi kevin,
> >
> > here is the fix for this problem.
> >
> > best
> > andreas
>
> Andreas,
>
> I programed and ran V7 last night and it seemed
> that can only run my x and y axis in one
> direction?? It might be me also tonight I was
> going to try the one that is on source forge as a
> base line to see if that works in both directions
> since I just rewired my stepper motor (my X was
> not the one that was reversed it was my Z)
>
> So I will let ya know.
>
> Bruce

MY bad, I found I had the min. "end stop jumper" on the wrong pins. When I was testing the Robot I am pulling the end stop pin to simulate the end stop till I get the time to wire and install the end stops ( hopefully this weekend! )
so all is good I al running V7 of the firmware and all seems to be running well..

Bruce