Welcome! Log In Create A New Profile

Advanced

Extruder reversed

Posted by urbanzakapa 
Extruder reversed
May 04, 2014 03:51PM
Guys,
I have a problem with my extruder and reverse settings in my pronterface. When I try to extrude the PLA, it start to pull it out from the extruder and when I click 'reverse' it extrudes the PLA. To make it simple, it likes both function is swapped. So, is there any way that I can make sure that both 'extrude' and 'reverse' settings works fine in which when I asks the machine to extrude, it extrudes and when I click 'reverse' it reverses.

Ramps 1.4
Prusa Mendel i2
Sprinter

Thanks
Re: Extruder reversed
May 06, 2014 03:00PM
Make sure your extruder stepper motor is wired up correctly. If it is, you can either reverse it in the firmware or reverse the wiring. Guide to stepper wiring (including reversing).
Re: Extruder reversed
May 08, 2014 10:51AM
Quote
3dkarma
Make sure your extruder stepper motor is wired up correctly. If it is, you can either reverse it in the firmware or reverse the wiring. Guide to stepper wiring (including reversing).

Thanks, works fine.
Sorry, only registered users may post in this forum.

Click here to login