Welcome! Log In Create A New Profile

Pronterface- Center part on print bed?

Posted by roygpa

roygpa

Pronterface- Center part on print bed?
November 13, 2011 09:35AM

Registered: 12 years ago
Posts: 108

I am at the testing phase with my Prusa and pretty much calibrating and printing "air parts." When I use pronterface "printer interface" it seem to always position the part on the right rear quadrant of the print bed. Is there a way to tell the program to center the part on the bed?

Thank you in advance.

Roy

Reply Quote

buzz

Re: Pronterface- Center part on print bed?
November 13, 2011 11:29PM

Registered: 15 years ago
Posts: 62

change your skeinforge or sfact settings to enable "raft", and then look at the other settings on that tab. :-)

Reply Quote

rhmorrison

Re: Pronterface- Center part on print bed?
November 14, 2011 02:35AM

Registered: 14 years ago
Posts: 3,742

You use the Multiply plugin - Activate it and set center x,y at 100,100.

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse