Welcome! Log In Create A New Profile

Advanced

reprap hotend

Posted by mellis 
reprap hotend
August 01, 2011 03:33PM
ok so it looks like my mendel-parts v4 has died (again) and since i have been out the loop as far as deveopments and new products go for a while. i was woundering what hotends are the best out there?

my only requirements are it has to be around or under £60 and in stock now (i need to get it running quick)

thanks in advance


matt
Re: reprap hotend
August 01, 2011 05:49PM
Hello,

There are many hot-ends available. Since you are asking for it in Pounds, how about [www.thingfarm.org] They have the "Geared Extruder Nozzle" and the J-Head Nozzle in stock.

Regards,

Brian



mellis Wrote:
-------------------------------------------------------
> ok so it looks like my mendel-parts v4 has died
> (again) and since i have been out the loop as far
> as deveopments and new products go for a while. i
> was woundering what hotends are the best out
> there?
>
> my only requirements are it has to be around or
> under £60 and in stock now (i need to get it
> running quick)
>
> thanks in advance
>
>
> matt
Re: reprap hotend
August 02, 2011 05:53AM
eMakershop.com has some for sell.
You will need to supply your own RP parts.


__________________________________________________________________________
"I like to be, what I like to see, in you and me.
I am the Stallion, Mang."

ISTAR Scope Club
amk
Re: reprap hotend
August 02, 2011 12:16PM
Hi Matt,

My v4 died a few weeks back also, after about 4 mths of loyal service. I ordered a superpack from makergear which shipped the same day. Cost me around 115$ to get it to Ireland - not sure what that is in sterling. I've not pushed it hard yet but I can get 60 mm/s where I couldn't get decent quality beyond 30 mm/s with the v4. Anyway theres quite a few other hotends out there (mendel-parts have a v6 now) but thats my experience fwiw.

All the best,

Alan.
Re: reprap hotend
August 03, 2011 10:18AM
Wildseyed Simple Hot End is my design. DIY parts $25 USD $50 Built and Wired. $100 mounted on a Gregs hinged extruder.
Sorry, only registered users may post in this forum.

Click here to login