Welcome! Log In Create A New Profile

Advanced

110v SSR Bed PWM setting in marlin

Posted by Bill Clark 
110v SSR Bed PWM setting in marlin
April 06, 2018 05:34PM
Installing 500w 110v silicone heater and read somewhere I should set PWM freq. to lowest setting for this set up. Also saw this commented in Marlin but where is the actual setting? right in front of my face I'll assume. What should I set it at?
Re: 110v SSR Bed PWM setting in marlin
April 07, 2018 07:04AM
Disregard. I dont think anything needs to be changed. Its doing very well as is (see attachment). Probably need to run an autotune on the hotend again though. On a side note Im trying some 12v 50w heaters
i got off ebay which are the same dimensions as the 30w. These things kick butt. 25-370c in a little over 2.5 minutes. 25-160c in 2 minutes for new bed heater. No more waiting for temps .........yippee
Attachments:
open | download - time to temp2.jpg (359.8 KB)
Sorry, only registered users may post in this forum.

Click here to login