Hello All,
Been trying for a couple of days to get my 2208's working in uart mode. What ever I try I cannot seem to change the current or step mode via marlin.
I have the fystec versions, i have soldered the CFG pads on the bottom, have a wire running from the PDN pin to pin 59 on the ramps. All jumpers under the driver removed, made all the changes to marlin.
when i run m122 it still says unabled = false, and there no driver register address for the chips.
Can anyone help me out with this?
Thanks
[
imgur.com]
[
imgur.com]
[
imgur.com]