Welcome! Log In Create A New Profile

Advanced

Makergear M2 Red Led

Posted by Davebro 
Makergear M2 Red Led
December 03, 2017 05:02PM
Have a Rambo board. Plugged it in after being down a few weeks. When I go to turn on the Hotbed I get a red led that stays on with a buzzer noise. Any ideas?
Re: Makergear M2 Red Led
December 07, 2017 05:30PM
. I've had the printer disconnected for a couple of weeks. Hooked it up to do a print, and leveled with the app. went fine until time to heat the bed. I get a red led lit and a buzzer. going to try and link the video of it at the end. I've checked every connection, replaced connectors on the HBP, even re soldiered the wire. Reloaded firmware, nothing makes a difference will do it in any slicer. m2 with 4 point, silver Z motor, bottom z-stop and dual V4's.

Makergear has no idea. 3rd or 4th board in 15 months.
Sorry, only registered users may post in this forum.

Click here to login