Welcome! Log In Create A New Profile

Advanced

Quick question on this board.

Posted by DjDemonD 
Quick question on this board.
October 11, 2017 06:39AM

? Melzi board from cr10.

Are the 2 pin endstop connectors GND and SIG? Or is one VCC?

Trying to advise how to connect our piezo sensor which has 3.3v-5v in, SIG, GND and works NO.

Edited 3 time(s). Last edit at 10/11/2017 07:27AM by DjDemonD.

[www.precisionpiezo.co.uk] Accurate, repeatable, versatile z-probe.
[www.facebook.com] we want to see your first layer photos... give us a like/share


[www.thingiverse.com] DemonDeltaMicro - Micro Delta Printer & Things I've made/remixed.

Re: Quick question on this board.
October 11, 2017 03:28PM
[ cynical mode ]
And you want us to do your work for you?
Maybe a incentive like a free probe to the best working solution would help to motivate us who don't get payed for this.
[ /cynical mode]


two pin endstops are normally gnd and signal.
Can find no information on this other than a name "Creality Cr-10 3D Printer Motherboard"

I would take a good look at the USB/vreg jumper. As an educated guess the pins are probably: 5v from vreg, input to main board 5v bus, 5v from usb. If so you could make up a two pin connector to replace the jumper, that takes power, and connects it to usb or vreg just like the jumper did. (or just solder a wire to the jumper)

Edited 8 time(s). Last edit at 10/11/2017 03:51PM by Dust.
Re: Quick question on this board.
October 11, 2017 04:34PM
[serious mode] Where would you like your free sensor sent?[/serious mode]

I did find an entry on thingiverse where someone called this board a s-melzi but nothing else.

Edited 1 time(s). Last edit at 10/11/2017 04:36PM by DjDemonD.

[www.precisionpiezo.co.uk] Accurate, repeatable, versatile z-probe.
[www.facebook.com] we want to see your first layer photos... give us a like/share


[www.thingiverse.com] DemonDeltaMicro - Micro Delta Printer & Things I've made/remixed.
Sorry, only registered users may post in this forum.

Click here to login