Welcome! Log In Create A New Profile

Advanced

Repetier server running on Raspberry Pi 3 model B

Posted by boylucky 
Repetier server running on Raspberry Pi 3 model B
September 22, 2017 10:11AM
Hello,

I would like to ask you about your experiences with Repetier server running on Raspberry Pi 3 model B. Does anybody control multiple printers on one Raspberry Pi ? Currenlty I am using Repetier server on RP 2 and I am happy with it. I control only one printer there for now.

Thanks for your answers.
Re: Repetier server running on Raspberry Pi 3 model B
September 22, 2017 10:53AM
I ask this question not to long ago, an though the Raspberry Pi software can handle running multiple instances of the software.
It is being pushed, an with the cost being so low, was told it make sense to have one per 3D Pinter.

However there is lot of information on how to setup for two 3D Printers.
Re: Repetier server running on Raspberry Pi 3 model B
October 06, 2017 07:50AM
I have successfully tested the RPI3 model B with 2 printers today. Looks ok and the prints on both delta printers are currently running without problems.
Sorry, only registered users may post in this forum.

Click here to login