Survey on Beds sizes for build plates

My webside currently sells a range of different build plates in a small range of sizes 6, 8, 12 and 17 inch square for AndOrNot build plate, PEI and Lokbuild.

I am trying to determine what people want in build plate sizes as there maybe cost savings for the end user if i say offer 15 inch square rather than having to pay for a 17 inch build plate. The size changes for Lokbuild are out of my control as i am a reseller for Lokbuild, but AndOrNot and PEI build plate can be cut whatever size is more economical for the users.

Please reply to this thread and state the size of bed require and from the responses, i will produce a matrix of sizes and costs to better meet the market demand.

Edited 1 time(s). Last edit at 09/14/2017 05:26AM by andornot.

---

www.andornot.co.uk, selling new products, including smoothie boards and other useful parts for 3D Printers:

AndOrNot buildplate launched, available in 6 inch, 8 inch, 12 inch and 17 inch square introductory discount code "20reprap"
And Or Not Build Plates

I have 100mm circular, 330mm circular and 200x300mm.

---

Simon Khoury

Co-founder of [www.precisionpiezo.co.uk] Accurate, repeatable, versatile Z-Probes
Published:Inventions

I have 330mm circular, 210x210, and approx. 300x200.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

the mk3 alu 213x213 mm here

My home printer, as well as the one I use at work, are both pretty close to 12 inch square.

---

Help improve the RepRap wiki! Just click "Edit" in the top-right corner of the page and start typing. Anyone can edit the wiki!

300x300 square

What do you define as "build plate"?

Bed ---- the flat surface required for good print?

Glass, Aluminum, other

Heated

How is your build sheet held to/down to bed?

my size 300mm x 300mm glass heated
I print directly on glass

My build plate is stuck down with 3m double side tape. If you only print on glass then this thread does not apply, although in the future you may want a PEI or our own build plate.

---

www.andornot.co.uk, selling new products, including smoothie boards and other useful parts for 3D Printers:

AndOrNot buildplate launched, available in 6 inch, 8 inch, 12 inch and 17 inch square introductory discount code "20reprap"
And Or Not Build Plates

250x320mm cast aluminum plate with PEI sheet

---

Self-sourced Mendelmax 2.0-based Reprap Machine -- Ramps 1.4 & Mega 2560 -- DRV8825 (Z@1A, [email protected], [email protected], E@1A) -- genuine E3D v6 direct setup -- 350W custom silicone heated bed -- ABS 1,75mm -- Marlin 1.1.0-RC7 -- Cura 15.04.6

Andornot, please stop reposting your "survey" in every subforums, it's spam. I'm leaving just this one topic.

---

Most of my technical comments should be correct, but is THIS one ?
Anyway, as a rule of thumb, always double check what people write.